Forum Home Forum Home > Flight One Partner Forums > EZdok Software
  New Posts New Posts RSS Feed - EZCA and FS2Crew
  FAQ FAQ  Forum Search   Register Register  Login Login

EZCA and FS2Crew

 Post Reply Post Reply
jsmcwilliam View Drop Down
Intermediate Group
Intermediate Group

Joined: September-29-2013
Location: Malmö
Points: 42
Post Options Post Options   Thanks (0) Thanks(0)   Quote jsmcwilliam Quote  Post ReplyReply Direct Link To This Post Topic: EZCA and FS2Crew
    Posted: May-11-2022 at 4:03am

I run my Dash 8 Q400 with P3D v5.3 under windows 10. I also have the FS2Crew and EZCA addons.I have a problem when I get to the TakeOff Procedure in FS2Crew - the copilot readouts do not occur and I cannot communicate with FS2Crew until I get to the Climb Procedure.My solution for this has been to turn EZCA off during the TakeOff Procedure and turn it on again during the climb.This is the case at all airports and does noy apply to my other aircraft (PMDG 737 NGXu). There would thus appear to be a conflict between FS2Crew and EZCA during the TakeOff Proc. Does anyone have the same problem? Is there a solution?

John McWilliam
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.04
Copyright ©2001-2021 Web Wiz Ltd.

This page was generated in 0.140 seconds.