Print Page | Close Window

FSiPanel2020 - testing

Printed From:
Category: Flight One Partner Forums
Forum Name: FSiPanel
Forum Description: Official FSiPanel Support Forum
Printed Date: June-25-2022 at 10:15pm
Software Version: Web Wiz Forums 12.04 -

Topic: FSiPanel2020 - testing
Posted By: jsmcwilliam
Subject: FSiPanel2020 - testing
Date Posted: November-13-2020 at 9:31am
I run P3Dv5.1 under Windows 10. Active Sky was not used but I do depend on EZCA when flying and this was active. I uninstalled FSiPanel2017 before running this test.

I have followed the instructions placing my PMDG 737 NGXu at EHAM and then starting FSiPanel. My aircraft was recognised and I was able to position on a short final runway 18R after weight adjustment.

1. I was positioned at 1000 ft which was under the glideslope. The FMS, radio and autopilot settings appeared to be correct.
2. I armed the approach.
3. The window for taking control of the approach was behind my cockpit window so it took a while to realise this and start the approach.
4. I flew the approach without any problems.
5. Returned to FSiPanel and examined the landing report then chose to move back into position for another appoach. This time I got an error or warning: LockheedMartin.Prepar3D.SimConnect.SIMCONNECT_RECV_EXCEPTION. I ignored this and continued for the second approach.
6. This time there were some stutters on the approach and after landing the report flashed by and I did not have time to examine it.
7. I flew a third approach, again with the above error when moving the aircraft and then some stutters on the approach. This time it was not possible to view the landing report - it would not open.

I will some more approaches and report on them later.

John McWilliam


Posted By: USN O6
Date Posted: November-13-2020 at 12:26pm
Hi John,
That support forum is now here:" rel="nofollow -


Print Page | Close Window

Forum Software by Web Wiz Forums® version 12.04 -
Copyright ©2001-2021 Web Wiz Ltd. -