SimForums.com Homepage
Forum Home Forum Home > Flight One Partner Forums > EZdok Software
  New Posts New Posts RSS Feed - Config.exe can't find p3d v4
  FAQ FAQ  Forum Search   Register Register  Login Login

Config.exe can't find p3d v4

 Post Reply Post Reply
Author
Message
09RKC View Drop Down
Intermediate Group
Intermediate Group


Joined: August-05-2013
Location: Bartlett, TN
Points: 49
Post Options Post Options   Thanks (0) Thanks(0)   Quote 09RKC Quote  Post ReplyReply Direct Link To This Post Topic: Config.exe can't find p3d v4
    Posted: September-07-2017 at 5:44pm
Hi all!
 
Purchased EZdok 2 a few hours ago. I can't seem to get it fully installed.
 
1 - I ran EZdok-2-Setup.exe from c:\EZDok Software, that part seemed to do fine.
2 - The box "NOTE: Before use utility, you should connect...". I clicked OK and get "Select version of a simulator", and I see 3 options... FSX, P3D v3 and P3D v3. P3D v4 isn't there.
 
Per instructions, I copied the content of c:\EZdok Software to c:\Program Files (x86)\EZCA2. Didn't help.
 
My P3D v4 is on another SSD, not c:\ if that matters. When clicking ezlauncher.exe and/or EZCA.exe I get "P3D/FSX process not found. Application can not run".
 
I'm almost there, can anyone help me this last bit? Sure would appreciate it!!
 
Tkx!
Doug
Doug
Back to Top
09RKC View Drop Down
Intermediate Group
Intermediate Group


Joined: August-05-2013
Location: Bartlett, TN
Points: 49
Post Options Post Options   Thanks (0) Thanks(0)   Quote 09RKC Quote  Post ReplyReply Direct Link To This Post Posted: September-07-2017 at 6:35pm
I've made a little progress by installing v2.5.
Config/exe v2.5.0.20 now sees P3D v4 and runs seamlessly, but EZCA2\2.5 beta 64 built 11\EZCA.exe still says it can't find "P3D/FSX process...".
Help plz!
Doug
Doug
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.156 seconds.